Some accessories cannot be purchased through our shopping cart. Please call or email Kinex Cappers for pricing and lead-time.
Choose accessories to make your LS Cap Tightener perfectly suited
for your specific tasks,
production environment, or the caps and bottles you work with.
Lever Activated Bottle Gripping Base
The Lever Activated Base perfectly centers the bottle in preparation for capping and holds the bottle to prevent it from spinning during the capping process. The four continuously adjustable grippers can be set to center and hold any bottle regardless of its shape. It is available with the SA™, ES Table Top™, PumpCap™, ES™, PS™, and LS™ Cap Tighteners.
The Lever Activated Base is particularly well suited for use with very short or narrow bottles. Very short containers are difficult to hold during the capping process. There is very little space for the operator’s hand to safely hold the container without being too close to the cap when the machine is tightening it. The Lever Activated Base holds the bottle firmly and allows the operator to remove their hands from the capping area while the cap is being tightened, enhancing the safety of the capping process.
The Lever Activated Base works with bottles up to 6.5 inches in diameter. It is constructed of 304 stainless steel and hard coat anodized aluminum for outstanding corrosion resistance.
Price: $775 Buy Now
PST-100 Capping Machine Support Stand
The column of the stand is 42 inches high and the arm is 30 inches long. The arm can swivel 360 degrees about the column. The Capper Balancer is attached to the arm and can slide freely along the entire length of the arm.
The swiveling and sliding action of the arm and Balancer allow for excellent freedom of movement and enables you to cap over a large area. The stand also makes for easy mounting and organizing of the capping machine, Capper Balancer and air hoses.
The stand comes complete as shown with a Capper Balancer, coil air hose, and a 6 foot length of air hose to connect to your in-house air supply.
Price when purchased with an LS Cap Tightener: $200
To complete purchase please continue to the LS Pricing Page.
Price if purchased separately: $250 Buy Now
The stainless steel bench Clamp allows you to fasten the PST-100 Capping Machine Support Stand to your table without screwing the base of the stand directly into your table.
Price: $39 Buy Now
Machined chucks are custom made to fit the rib pattern of a particular cap. They fit the cap in the same way as a socket fits a nut. Machined chucks provide extreme gripping power that make them very useful for certain types of challenging jobs. A few of which are described below.
The vast majority of de-capping jobs require a machined chuck. In most cases a standard chuck with urethane insert cannot provide enough gripping power to remove a tight cap. Generally what occurs is that the urethane liner simply skids over the cap without removing it.
Machined chucks grip a cap so perfectly that it makes the removal of even the tightest of caps very easy.
- Clean Environments
The urethane or white rubber inserts within a standard chuck will wear slowly over time and can occasionally leave very small amounts of urethane or white rubber particles on the caps they tighten. These particles may not be allowed in certain clean, sterile or controlled environments.
Machined chucks are ideal for clean environments since they do not wear and do not create particles.
Machined chucks also improve torque accuracy and never have to be replaced.
- Extreme Torque Applications
When a cap has to be applied with an unusual or extreme level of tightness, a machined chuck is the perfect solution. A machined chuck can always apply as much torque as is necessary and will do so quite easily. Machined chucks also improve torque accuracy and never have to be replaced.
Machined chucks cannot be purchased through our shopping cart. Please call or email Kinex Cappers for pricing and lead-time.